I've soldered the wires of a controller extension cable in the order red-white-black but I can't get the controller buttons to register on my PC.
It looks like I need to order some resistors, but do I install them vertically or diagonally like in this picture?
https://www.retrode.com/wp-content/uploads/2012/09/n64-oldnew.jpg
There was a board revision that fixed the diagonal resistors.
If your PCB is the v0.4 version dated 2012-08-26, then install the resistors vertically.
Good Luck!
Quote from: skaman on 04/Oct/2017 05:42:09 AM
There was a board revision that fixed the diagonal resistors.
If your PCB is the v0.4 version dated 2012-08-26, then install the resistors vertically.
Good Luck!
Thank you.
After looking up 220Rs I see I have a choice for wattage, should I use 1/4w, 1/2w, or 1w resistors?
1/4W. The package is 0207/10.
Quote from: skaman on 04/Oct/2017 05:47:28 PM
1/4W. The package is 0207/10.
Thanks again. :)